I. Preparation Before starting the wire forming machine, the following preparations need to be made:
1. Clean the machine surface. Clean the dust and dirt off the machine surface to avoid affecting normal operation.
2. Check the wire supply. Check if the wire supply meets the requirements and if the connection is stable.
3. Check equipment safety. Check if all parts are installed properly, if all terminals are connected correctly, and if there are any loose connections.
II. Power Connection Connect the power plug of the wire forming machine to the compatible socket and turn on the power switch. At this time, the power indicator light at the end of the machine will light up.
III. Check the power indicator lights After turning on the power switch, check the power indicator lights in different locations on the equipment to ensure that all indicator lights are lit normally. These indicator lights include: power indicator light, control indicator light, and program execution indicator light.
IV. Main Unit Startup Operation After completing the above steps, you can start the main unit. The specific steps are as follows:
1. Press the main unit power switch and wait a few minutes.
2. Check if the main control panel displays correctly.
3. Press the start button to enter the equipment's operating interface.
IV. Equipment Debugging After the wire forming machine has been started, it needs to be debugged. Debugging mainly includes adjusting various machine parameters, such as the forming plate parameters and processing speed. Only after these are adjusted to suitable settings can formal forming operations begin.
